狠狠色丁香久久综合婷婷亚洲成人福利在线-欧美日韩在线观看免费-国产99久久久久久免费看-国产欧美在线一区二区三区-欧美精品一区二区三区免费观看-国内精品99亚洲免费高清

No Calibration for 1 Year

An internal standard calibrates the instrument with every reading. Factory calibration and membrane replacement are unnecessary. Periodic wiping of the sensor with a wet rag is all that is required for continuous measurement.

No drift, 99% Accurate LDO Technology

The sensor is unaffected by pH swings, hydrogen sulfide, wastewater chemicals, heavy metals, or organic build-up on the sensor. Warm-up time is unnecessary so the analyzer can start measuring within 30 seconds of when it’s turned on.

No Membranes, Simple Installation and Maintenance

The HACH LDO probe can be installed with a choice of pole or ball-float mounting kits. The probe has only one inexpensive replacement part—the sensor cap that is simple to replace. The sensor cap is warranted for one year. The probe is warranted for three years.

Method of Detection

The HACH LDO sensor is coated with a luminescent material. Blue light from an LED is transmitted to the sensor surface. The blue light excites the luminescent material. As the material relaxes it emits red light. The time for the red light to be emitted is measured. Between the flashes of
blue light, a red LED is flashed on the sensor and used as an internal reference.
Increased oxygen in the sample decreases the time it takes for the red light to be emitted. The time measurements correlate to the oxygen concentration.

Full Featured “Plug and Play” sc Digital Controllers

There’s no complicated wiring or set up procedures with the Hach sc100 controller. Just plug in any Hach digital sensor and it’s ready to use—it’s “plug and play.”
One or two sensors—Use the sc100 Digital Controller to receive data from up to two Hach dig

Specifications

Accuracy:Below 1 ppm:
± 0.1 ppm Below 1 ppm

Accuracy 2:± 0.2 ppm Above 1 ppm

Accuracy 3:Temperature: 
± 0.2 °C

Hazardous Location Ratings:ETL listed （cETLus marked） to Canadian and US General Safety and Hazardous （Class l, Div. 2） Locations

Measurement range:0 to 200 % saturation

Measuring Range:to

Operating Temperature Range:0 to 50 °C

Pressure Limit:max

Repeatability:± of span

Resolution:± Below 10 ppm 1% saturation

Response Time:at 20ºC: To 95 % in less than 60 seconds

Response Time - 20 °C:To 90 % in less than 40 seconds

Sensor Immersion Depth:Pressure Limits at 107 m 1050 kPa （350 ft.）, 1050 kPa （150 psi）, maximum

Sensor Thread:Inner thread

Storage Conditions:-20 °C to 70 °C

Transmission Distance:1000 m （3280 ft.） maximum when used with a termination box

Warranty:3 years

Weight:3.09 lbs. （1.4 kg）

Wetted Materials:Foamed Noryl® and 316 stainless steel